1 files changed, 0 insertions, 3 deletions

diff --git a/10.-KerberosSDR-Setup-for-KrakenSDR-Software.md b/10.-KerberosSDR-Setup-for-KrakenSDR-Software.md
index 79cf889..96a9cd0 100644
--- a/10.-KerberosSDR-Setup-for-KrakenSDR-Software.md
+++ b/10.-KerberosSDR-Setup-for-KrakenSDR-Software.md
@@ -19,9 +19,6 @@ Once the EEPROM is flashed you can reboot and follow the reconfiguration step be
 ## KerberosSDR Reconfiguration (For DoA Software)
 The image is currently set up for the KrakenSDR. For KerberosSDR users, please update the EEPROM as described above first, then reboot. Once the web interface has loaded, expand the "Basic DAQ Settings" by clicking on the checkbox. Under "Preconfigured DAQ Files" select "kerberosSDR_default", and then click on "Reconfigure and Restart DAQ chain". This may take a minute or so, but after it's completed the software should connect and begin processing.
 
-## KerberosSDR Reconfiguration (For PRSoftware)
-For the Passive Radar software you can use the same "pr_" prefixed preconfiguration files as used by the KrakenSDR.
-
 ## KerberosSDR Retuning
 The KrakenSDR code is designed to autocalibrate phase on each retune. Unfortunately this feature is not available on the KerberosSDR due to the lack of a noise source switching circuit. So with the KerberosSDR every time you change the frequency or DAQ settings, you must make sure that you have the antennas disconnected. (NOTE: This is only a problem for the DoA software which requires sample and phase calibration. For PR only sample calibration is required, and hence retuning should be fine without needing to disconnect antennas.)